Danuser Pallet Forks User Manual download pdf (Page 7)

Prepare the Vehicle

Read and understand the manual for your vehicle before assembling or installing the pallet

fork. The use of the pallet fork may require the addition of counterweights to ensure the

combined weight of the attachment and load does not exceed the rated capacity of your

vehicle.

STEP 1: Park the vehicle on level ground, and install the frame (1) by following your

vehicle operator’s manual for installing an attachment. Be sure to securely latch

the frame (1) to the vehicle.

STEP 2: Completely lower the vehicle loader arms and fully roll the dump cylinders back.

If the bottom rail of the frame (1) is in contact with the ground, then slightly raise

the vehicle loader arms.

STEP 3: Shut off the vehicle engine and remove the key.

STEP 4: Grease the frame (1) rails to reduce wear and make adjusting the tines (2) easier.

STEP 5: Position the first tine (2) in the center notch (3) of the frame. Place the top tine

tab on the top rail first, so that the bottom tine tab goes into the notch (3) on the

bottom rail. Lift the lever (4) and slide the tine (2) to the right. Repeat this

process for the second tine (2), and slide it to the left.

STEP 6: Flip up the levers (4), and slide the fork tines (2) to the desired width. Each tine

(2) must be the same distance from the center of the frame (1).

STEP 7: Flip down the levers (4), and secure fork tines (2) by sliding the latches into the

frame rail notches.

Assembly &

Installation

The bottom rail of the frame should be slightly off the ground to allow

installation of the fork tines.

Personal protection

equipment including

hard hat, safety glasses,

safety shoes, and gloves

are recommended during

assembly, installation,

operation, maintenance,

removal, or movement of

the pallet fork.

Always use two

people to handle

heavy, unwieldy

components during

assembly, installation,

maintenance, removal,

or movement of the

pallet fork.

Never place your hands or fingers between the frame and

the fork tine, especially when adjusting tines.

Keep the fork tines adjusted to the maximum width for better load stability.

= Safety Sign

Location

WARNING

NOTE

fork tine

capacity

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Comments to this Manuals

No comments

Danuser Pallet Forks User Manual Page 7

Comments to this Manuals

Related products and manuals for Hardware Danuser Pallet Forks